MOTOREX COOL-X AW Coolant for spindle systems 26% ready-to-use 200L

MOTOREX COOL-X AW is a ready-to-use high-performance spindle coolant with specially formulated lubricant additives. It is designed for closed-loop spindle cooling systems with increased sliding friction requirements, for example when rotary/tilting tables are cooled from the same tank. Supplied ready-mixed at 26%.

• Pack size: 200 L drum
• Also available in: 60 L drum, 20 L canister 
• Cleaning note: 2–3 days before product change, clean the circuit with MOTOREX CS-CLEANER (see dosage below).

Applications

• Closed-loop spindle cooling systems in machine tools
• Systems where, in addition to the main spindle, rotary/tilting tables are cooled from the same coolant tank

Features

• Lubricant additives with optimized sliding friction values (supports wear reduction on mechanical seals in rotary unions)
• Highly efficient heat removal
• Corrosion protection for steel, aluminium and non-ferrous metals
• Ready-to-use and low-maintenance

Technical Data

Commissioning & Maintenance

• Initial commissioning: flush the circuit with potable water (circulate ≥10 minutes), then drain completely.
• Routine checks: monitor pH and concentration (observe refractometer factor); target values according to the technical data sheet.
• Topping up: compensate evaporation losses with ready-mix; if concentration reaches the upper limit, correct with clean potable water.
• System cleaning before product change (CS-CLEANER): dosage 3% of total system volume — examples:
  • at 20 L system volume: 0.6 L CS-CLEANER
  • at 60 L system volume: 1.8 L CS-CLEANER
  • at 200 L system volume: 6.0 L CS-CLEANER
  Recommendation: MOTOREX CS-CLEANER 1 L or 5 L.

MOTOREX AG, Bern-Zürich-Strasse 31, 4901 Langenthal, SWITZERLAND, +41 62 919 75 75, [email protected], www.motorex.com