Loctite SF 7452 Cure-speed accelerator 18ml pump bottle

LOCTITE® SF 7452 Cure-speed accelerator 

LOCTITE® SF 7452 Accelerator is a transparent, light amber, cure-speed accelerator for the increased cure speed of LOCTITE cyanoacrylate/instant adhesives. It is suitable for both pre- and post-application and offers an improved cosmetic appearance by avoiding the white discoloration of instant adhesives. It is especially suited for post-application on instant adhesives to ensure rapid fixturing.

Application

• This product is typically used in applications that include securing wires or coils to PCBs, tamper-proofing adjustable components, mounting stand-offs, edge guides, and board stiffeners.

Characteristics

• Cures excess adhesive
• Provides excellent cosmetic appearance avoiding the white discolouration of instant adhesives
• Suitable for pre- or post-application
• Not recommended on plastics prone to stress cracking
• IMPORTANT NOTE: This product was upgraded in 2021/2022. Please utilise the product IDH/item number to ensure correct SDS is downloaded.

Technical specifications

Technology	Activator for Cyanoacrylate
Chemical Type	Organic disulphide (active ingredient)
Solvent	Acetone
Appearance	Transparent to slightly hazy liquid
Viscosity	Very low
Application	CA adhesive cure accelerator

---

Hazard Information (CLP)

Signal word: Danger

Hazard Statements (H-Sentences)

• H225: Highly flammable liquid and vapor.
• H317: May cause an allergic skin reaction.
• H319: Causes serious eye irritation.
• H336: May cause drowsiness or dizziness.

Prevention (P-Sentences)

• P210: Keep away from heat, sparks, open flames, and hot surfaces - no smoking.
• P233: Keep container tightly closed.
• P273: Avoid release into the environment.
• P280: Wear protective gloves, eye protection, and face protection.

Response (P-Sentences)

• P302+P352: IF ON SKIN (OR HAIR): Take off immediately all contaminated clothing.
• P304+P340: IF INHALED: Remove victim to fresh air and keep at rest in a comfortable position for breathing.
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes.
• P333+P313: If skin irritation or rash occurs: Get medical advice/attention.
• P337+P313: If eye irritation persists: Get medical advice/attention.

Storage and Disposal

• Store in a well-ventilated place. Keep container tightly closed. Store cool.
• Dispose of contents and container according to Federal, State/Provincial, and local regulations.

 

Information on product safety (Manufacturer, Contact)

Henkel AG & Co. KGaA, Henkelstr. 67, 40589 Düsseldorf, GERMANY, +49 211 7970, [email protected], www.henkel.com