Klüber WOLFRACOAT C FLUID High-temperature lubricating compound 20L

WOLFRACOAT C FLUID High-temperature lubricating compound | N° 099118

• WOLFRACOAT C FLUID is a viscous high-temperature release agent and lubricating compound based on a mineral and ester oil mixture. It contains solid lubricants, metal pigments and an inorganic thickener.
• The base fluid starts to evaporate at approx. 200°C, leaving a solid lubricant film, which separates frictional surfaces (dry lubrication).
• Temperature range: -25°C to +1050°C 
• Volume: 20 L canister 
• Also available in: 1 L canister, 5 L canister, 200 L barrel

Benefits for your application

• Very good corrosion protection → increased component lifetime
• Ready-for-use → just mix vigorously
• Low consumption → low costs, high efficiency
• Easy application → reduces maintenance time
• Easier to mix in smaller canisters → less effort required
• No part-used stock → the 5 l pack size matches the tank of the Klübermatic KD spray pump

Applications

• WOLFRACOAT C FLUID was developed as a lubricating compound for surfaces subject to high thermal loads, as e.g. in rotary kilns in the base material industry (chemical industry, cement, ore processing, etc.) between the inner surfaces of the tyres and the kiln shell’s slide elements as well as the running surfaces of the axial supports.
• WOLFRACOAT C FLUID is also suitable for the lubrication of pouring ladles used in the steel industry, and could also be used as a screw compound for high-temperature bolt and screw connections. 

Application notes

• WOLFRACOAT C FLUID is usually applied to the area between the tyre and the kiln shell with the Klübermatic KD manual spray jet equipment (other commercially available spray devices can also be used). In other cases the product can also be applied by brush. Each tyre should be relubricated once a week with 2-3 litres of WOLFRACOAT C FLUID according to the tyre width. It is important to ensure relative motion between the tyre and the kiln shell. We recommend reference to the relative motion value stated by the OEM (between 10 and 30 mm)
• NOTE: Always shake WOLFRACOAT C FLUID vigorously prior to application, as the solid lubricants tend to settle out during storage. Without agitation, the spray jet would be filled only with the oil component, which would not provide dry lubrication following evaporation. Additionally, the oil component has an auto-ignition point of approx. 370 °C which may constitute a risk

Technical specifications