Klüberbio AG 39-602 Adhesive lubricant for open gears 25kg

Klüberbio AG 39-602 Adhesive lubricant for open gears 25kg

€ 1545.81 1,545.81 incl. VAT (1,299.00 excl. VAT), per piece *

Availability: on request

Packaging unit: 1 piece

Manufacturer: KLUBER

Country of origin: BE/0017

Customs tariff number: 27101999

Weight per piece: 26.8 kg

The product description does not help you?
No problem. Simply fill out the form and we will answer you as soon as possible.

Klüberbio AG 39-602 contributes to long component life and good corrosion and wear protection.
The finished product meets the biodegradability, minimally toxic and non-bioaccumulative standards established by the US EPA for the 2013 Vessel General Permit.
Klüberbio AG 39-602 contains > 60 % of renewable raw materials.
Temperature range: -20°C to +100°C
Volume: 25kg bucket
Also available in: Cartridge 400g, Can 1kg, Drum 200kg

Complies with the requirements for Environmentally Acceptable Lubricants as defined in Appendix A of the 2013 Vessel General Permit
Reduced environmental impact in the event of discharge into water. The base oil is derived from renewable resources
Good adhesion and water resistance for long relubrication intervals
Selected additives ensure longer component life and reduced wear
Corrosion protection under seawater influence due to especially selected anti-corrosion additives

Klüber Klüberbio AG 39-602 was developed for the lubrication of open pinion gears on winches and jack-up platforms, as well as steel cables in contact with water.
The product can also be used in other maritime applications that require lubricants to have good water washout resistance, very good anti-corrosion resistance and/or good load-carrying capacity such as with low-speed plain bearings, guide rails and open winch gears.

Klüber Klüberbio AG 39-602 can be applied continuously through transfer lubrication with pinion or by brush.
Compressed-air lubrication equipment can be used for the lubrication of steel cables.

Article number	009042
Chemical composition, type of oil	ester oil
Chemical composition, thickener	calcium soap
Lower service temperature	-20 °C / -4 °F
Upper service temperature	100 °C / 212 °F
Colour space	yellow
Texture	homogeneous
Texture	fibrous
Density at 20 °C	approx. 0.97 g/cm³
Worked penetration, DIN ISO 2137, 25 °C, lower limit value	290 x 0.1 mm
Worked penetration, DIN ISO 2137, 25 °C, upper limit value	330 x 0.1 mm
Kinematic viscosity of the base oil, DIN 51562 pt. 01/ASTM D-445/ASTM D 7042, 40 °C	approx. 600 mm²/s
Kinematic viscosity of the base oil, DIN 51562 pt. 01/ASTM D-445/ASTM D 7042, 100 °C	approx. 85 mm²/s
Flow pressure of lubricating greases, DIN 51805, test temperature: -20 °C	<= 1 400 mbar
Drop point, DIN ISO 2176, IP 396	>= 120 °C