Metal etching pen 0859 for metal engraving without cartridges

• These disposable pen is suitable for clearly etching codes, sizes and identification references on all steel & copper surfaces
• Ideal for the individual identification of workshop tools, instruments & machines
• The pen is delivered without cartridges.Suitable for permanent etching of codes, sizes and identification references on the following metal
• Surfaces: Alloy and Stainless Steel, Iron, Copper, Gun Metal, aluminium.The surface for marking should be clean and free from oil
• For light marking make only a single pass with the pen
• For darker marking, make repeated passes with the pen to achieve the legibility required
• Lightly wipe the surface following etching with light oil
• If etching agent is splashed on skin, wash with soap and water

METAL ETCHING PEN SETTING UP

Metal etching pen / cartridges disassembled

• A – Closing cap
• B – Rubber grip
• C – Two-sided screw thread centre piece
• D - Pen's end screwing piece

Exemple cartridges

• Cartridge 1a : Cartridge Nigrit 'VA' green without cap
• Cartridge 1b : Cartridge 'VA' green with cap
• Cartridge 2a : Cartridge "K-extra" blue without cap.
• Cartridge 2b : Cartridge "K-extra" blue with cap

Instructions for use

• Part of the pen for the spare cartridge (cartridge must be always closed), that you insert backwards from the back of the part C.

• Cartridge without cap (ready for use) to insert in the part B (Part with the rubber grip), then close it by screwing in the part C. At the end of use, replace the cap, Part A.

​